Cement-free, dispersible putty designed for the Capatect KD System 600 insulation system. It can be used as a renovation tile. Suitable for mounting protective corner profiles. On highly absorbent substrates it can be used as an adhesive.
Plastic profile with integrated fabric strip for a decoupled connection between plaster and on-site laminations.
Plastic mounting profile
Decoupled connection option for on-site laminations
Accurate recording in one flight by connector mounting
Targeted water management
Cardboard box of 25 pieces
For finishing the edges of corners with sharp or flared angles within Capatect systems.
125 x 125 mm fiberglass mesh profile with inner plastic cutter
The arms of the angle bar are not connected rigidly, which allows for individual fit in the case of sharp and bifurcated corners
Edges can be precisely prepared
Prevents the mesh from...
Description / Material
Preformed glass fabric profile for simultaneous use as an inner corner as well as a diagonal reinforcement.
High tensile strength
Mesh size 4 x 4 mm
For the performance of thin layers of putty and plaster in insulation systems in the system with mineral wool and Styrofoam. Also for use on concrete, old mineral plasters, limestone-cement and cement sludge groups PII and PIII.
Unsuitable are substrates with salt blooms, plastic and wood substrates, as well as heavily mechanically loaded...
CT 137 ceresit plaster is used for the production of thin-layer plaster on concrete substrates, conventional plasters, gypsum substrates and on gypsum boards, gypsum fiber boards, etc. It can be used as a facade cladding in ceresit systems, insulating the external walls of buildings by the light-wet method using foamed polystyrene...
Destination:Used, among others, as a surface treatment in systems: in the seamless insulation system Capatect CLASSIC B, on uncoated concrete, on Matt bearing surfaces painted with dispersion paints, on mineral bearing surfacesApplication surface:Uncoated concrete, primer plasters, mineral surface plastersAdditional information:Do not use on surfaces with...
Adhesive and grout for the installation of Meldorfer flat veneers in the exterior and interior in the Capatect facade systems.
Ready-to-use mortar for the bonding and grouting of Meldorfer flat veneers.
see technical data sheet
A2-s1, d0 according to DIN EN 13501-1 (non-combustible)
For the performance of weather-resistant coatings covering and bridging cracks on facade surfaces and concrete surfaces, as well as for the protection of substrates from adverse weather conditions and aggressive air pollution.
Water-based, environmentally friendly, low odour
Anti-CO2-sd CO2 > 50 m...
For the formation of vertical expansion joints within the Capatect ETICS A and B.
Type E: for flush joints
Type V: for joints in interior corners
Expansion joints can be precisely pre-worked
can be painted over
efficient execution in one operation
suitable for all insulation thicknesses
For forming ends or separating surfaces of plastering expeditions. Allows accurate and clean lateral separation of different structures or colors in one working plane.
- Plastic profile, perforated, with separating edge
- The same mesh as in the reinforced layer (preserved system materials)
- UV resistant
- Clean and clear...